 |
|
| 제품특징 | 제품사양 | 자료실 |
GuardII 장비의 회전기 모니터링 데이터
측정, 수집 및 통신을 위한 모듈
슬롯 형태로 GuardII Carrier Board에
장착하여 사용
GuardII 장비 부팅, 작동 상태, 회전기 데이터 모니터링 등을 LED를 통해 확인할 수 있음
| 제품특징 | 제품사양 | 자료실 |
Processor Module
Power Supply Status
LEDs
|
Behavior |
Meaning |
|
Off
|
No
power applied |
|
SUP
OK is blinking 3V3,
2V5, 1V2 and 1V25 are on |
No
problem detected. This is the normal operating state. |
|
SUP
OK is blinking One
of 3V3, 2V5, 1V2 or 1V25 is blinking |
The
power supply indicated by the LED has failed. |
|
All
are blinking |
AC
power failure detected |
CF Card Status LED
|
Behavior |
Meaning |
|
Off
|
This
is the normal operating state; this LED should be off except within the first
few seconds of a boot, or during a boot failure. |
|
Blinking
green |
Reading
data from the CF card. |
|
Blinking
Red |
The
CF card cannot be detected. |
|
Red
|
The
CF card was detected, but the necessary files were not found. |
Boot Status LEDs
|
LED |
Turns on when… |
|
1 |
The
kernel starts to load into memory |
|
2 |
The
kernel is loaded into memory |
|
3 |
The
kernel starts running |
|
4 |
The
startup scripts are running |
Carrier Board (Basically included in
GuardII)
Alert Status LEDs
|
Behavior |
Meaning |
|
Green
is off |
The
Alert relay is currently open |
|
Green
is on |
The
Alert relay is currently closed |
|
Amber
is off |
The
monitor is not currently in Alert |
|
Amber
is on |
The
monitor is currently in Alert |
|
Amber
is blinking |
The
Alert relay has been activated using the Alert button. |
Online/Offline LEDs
|
Behavior |
Meaning |
|
Green
is off |
The
monitor is currently offline. |
|
Green
is on |
The
monitor is currently online |
Ethernet Status LEDs
|
LED |
Meaning |
|
DUP
|
Indicates
if the connection is Full Duplex (ON) or Half Duplex (OFF) |
|
LNK
ACT |
Indicates
if the connection is detected (ON) and if there is activity (blinks OFF) |
|
SPD
|
Indicates
if the connection is 100Mbps (ON) or 10Mbps (OFF) |
|
COL
|
Indicates
if Ethernet collisions have occurred. |
Dimensions
300 x 120 x 38 mm
Monitoring Data
Partial Discharge, Rotor
Flux, End-winding Vibration, Shaft Current/Voltage in Rotating Machine
Input
Slotted in Carrier Board (GuardII)
Ethernet Port
(Carrier Board)
Connectors RJ-45 (TCP/IP, CAT5 or above)
Compatibility IEEE 802.3, 10Base-T/100Base-TX
Environmental
Conditions
Temperature
(operating/storage) 0 ºC to 55 ºC/-20 ºC to
55 ºC
Relative Humidity (max operating/storage) 95% non-condensing
Installation site Sheltered
and protected from direct sunlight